|
|
|
Instructions
to replace
the sofa covering |
Phase
1:
position the covering on the back
and on the armrests to start the covering
process and arrange the covering so that
the stitching is in line with the corners of
the sofa, after the zips that may be present
have been unfastened. Stretch the covering
by proceeding from the back towards the
sofa's front section until the sofa has been
completely re-covered.
Fasten the zips.
Phase 2:
position the covering on the edge
of the bottom corner – backrest - armrests
remove the strip and apply the Velcro (Fig. A).
Position the covering on the front part of
the seat so as to ensure the Velcro coincides
with the joint between the two covers
(Fig. B).
Phase 3:
stretch the covering over the
external parts of the sofa, remove the strip
and apply the Velcro along all the sofa edge
by turning the covering under the base (Fig.
C).
Phase 4:
insert the covering inside the groove
with the help of the palate supplied if the
foot is designed as shown in figure D.
Re-cover the cushions taking care to arrange
the padding in the right direction.
The stitching on the cushion's internal cover
must correspond to the zip on the covering
(Fig. F).
Ensure that the zip tab is inserted in its
relative holder (Fig. G).
Firstly position the side cushions and then
the central cushions if you are covering a
sofa that has more than two cushions.
Do not invert the position of the cushions
on the sofa.
|
|
|
